I am new to the home automation world and just set up my recently purchased HomeTroller-SE Pro 2.5.0.23 controller and 2Gig CT30 thermostat.
So far, so good. I have had no issues so far, except that I must have missed a step somewhere that allows me to adjust the CT30 thermostat controls from the HomeTroller (which is the primary reason I purchased this system).
My SE Pro is communicating properly with the CT30. I see three devices in the Device List and can poll them to get updated info:
Z-Wave Thermostat 2
Z-Wave Thermostat 2 Battery
Z-Wave Thermostat 2 Temperature
However, I see no way to remotely control the CT30 from the SE Pro?
The Control column on this page is empty for all three of the devices. I assume I should see a link or button to set the Temp?
If someone would be so kind as to tell me what setup step I missed it would be greatly appreciated!
Sorry if this has already been covered some other forum entry. I did try some searches but did not come across my situation. Thanks!
So far, so good. I have had no issues so far, except that I must have missed a step somewhere that allows me to adjust the CT30 thermostat controls from the HomeTroller (which is the primary reason I purchased this system).
My SE Pro is communicating properly with the CT30. I see three devices in the Device List and can poll them to get updated info:
Z-Wave Thermostat 2
Z-Wave Thermostat 2 Battery
Z-Wave Thermostat 2 Temperature
However, I see no way to remotely control the CT30 from the SE Pro?
The Control column on this page is empty for all three of the devices. I assume I should see a link or button to set the Temp?
If someone would be so kind as to tell me what setup step I missed it would be greatly appreciated!
Sorry if this has already been covered some other forum entry. I did try some searches but did not come across my situation. Thanks!
Comment