KeypadLinc Switch 2487S

[Leoleo]

Gurus,

I Installed a #2487S KeypadLinc Switch (v6.9 1246) and switched plates and modes to 8 button (they only come in 6 button). When adding the unit in PLM v1.7.3.1 the unit is recognized but shows as "Device Type 022C" with none of the associated links for all of the buttons. I tried resetting the device and resetting 6 to 8 button again, deleting and reinstalling in PLM. It does see the device, but not as a KeypadLinc. I tried resetting the device back to defaults and installing it as a 6 button unit, again it sees the unit but only as "Device Type 022C" with no button links. Any ideas how to get PLM to properly recognize the unit?


Thanks,

Leo

[mnsandler]

Leo,
looks like you got a new kpl device type. I'll need to post a new version to support this. I can post something later this evening. Hang in there.

[mnsandler]

please try the new beta on

http://board.homeseer.com/showthread...06#post1042006

it should support the registration of your new kpl.

[Leoleo]

Now that's service! I'll check it out shortly.

Thanks,

Leo

[Leoleo]

Mark,

New version works well, 2487S fully recognized and functional in 6 and 8 button modes.


Thanks again,

Leo