Hi all,
Following on a thread regarding Fibaro relays and dimmers not working with z-net in terms of calling back to HS3 when a switch is on/off from the wall, I have done a bit of reading and it seems it is to do with associations.
I did some messing around and sure enough it now reads when I flip the switch on/off from the wall though I'm not getting power readings yet.
So firstly by default after adding, I had the following:
Group 1 > Homeseer (ID: 1, Endpoint=1)
Group 2 > Homeseer (ID: 1, Endpoint=2)
Group 3 > Homeseer (ID: 1) Blank
Group 4 > Homeseer (ID: 1) Blank
Group 5 > Homeseer (ID: 1) Blank
What I did was delete Group 5, 4, 3 ,2
Left Group 1 alone.
I then added Group 3 > HomeSeer (ID, 1, Endpoint = 1)
This seemed to sort it out.
So was this correct method of doing it?
What I have noticed is on going back to the module just now to check the changes for this thread, all 5 are back the way they are listed above.
Not checked if the switch works as I'm not at home but why did it go back to how it was?
The reason I changed it is I found a thread about something similar and someone said to delete the associations and add a Group 3 to homeseer. but no instructions so I guessed
Thanks all
Following on a thread regarding Fibaro relays and dimmers not working with z-net in terms of calling back to HS3 when a switch is on/off from the wall, I have done a bit of reading and it seems it is to do with associations.
I did some messing around and sure enough it now reads when I flip the switch on/off from the wall though I'm not getting power readings yet.
So firstly by default after adding, I had the following:
Group 1 > Homeseer (ID: 1, Endpoint=1)
Group 2 > Homeseer (ID: 1, Endpoint=2)
Group 3 > Homeseer (ID: 1) Blank
Group 4 > Homeseer (ID: 1) Blank
Group 5 > Homeseer (ID: 1) Blank
What I did was delete Group 5, 4, 3 ,2
Left Group 1 alone.
I then added Group 3 > HomeSeer (ID, 1, Endpoint = 1)
This seemed to sort it out.
So was this correct method of doing it?
What I have noticed is on going back to the module just now to check the changes for this thread, all 5 are back the way they are listed above.
Not checked if the switch works as I'm not at home but why did it go back to how it was?
The reason I changed it is I found a thread about something similar and someone said to delete the associations and add a Group 3 to homeseer. but no instructions so I guessed
Thanks all
Comment