MS10A does not work correctly
I am having to configure the MS10 as a DS10. The MS10 reports its status as ON-OFF but in the event editor drop list does not have ON-OFF as testable states so it they are not usable in events.
If I configure the motion sensor as a DS10 it uses ALERT-NORMAL for the status and is testable in the events.
The odd thing about this is that I was sure it had been working when configured as a motion sensor previously. Not sure why it would change.
One other thing to note is that when configured as an MS10 the On and Off status icons both use the same green check mark and I am unable to edit these in the device manager.
I am having to configure the MS10 as a DS10. The MS10 reports its status as ON-OFF but in the event editor drop list does not have ON-OFF as testable states so it they are not usable in events.
If I configure the motion sensor as a DS10 it uses ALERT-NORMAL for the status and is testable in the events.
The odd thing about this is that I was sure it had been working when configured as a motion sensor previously. Not sure why it would change.
One other thing to note is that when configured as an MS10 the On and Off status icons both use the same green check mark and I am unable to edit these in the device manager.
Comment