Current Date/Time: 2/26/2018 10:03:44 PM
HomeSeer Version: HS3 Standard Edition 3.0.0.418
Operating System: Microsoft Windows Embedded Standard - Work Station
System Uptime: 11 Days 11 Hours 8 Minutes 46 Seconds
IP Address: 192.168.1.215
Number of Devices: 470
Number of Events: 48
Available Threads: 200
HSTouch Enabled: True
Event Threads: 0
Event Trigger Eval Queue: 0
Event Trigger Priority Eval Queue: 0
Device Exec Queue: 0
HSTouch Event Queue: 0
Email Send Queue: 0
Anti Virus Installed:
Enabled Plug-Ins
3.2.0.5: APCUPSD
1.2.2.0: Device History
3.0.0.103: LutronCaseta
3.0.5.7: SDJ-Health
3.0.6331.36036: UltraCID3
3.0.6616.28548: UltraM1G3
3.0.6554.33094: UltraMon3
3.0.5902.19061: UltraSMTP3
3.0.5712.31691: UltraWeatherBug3
3.0.1.199: Z-Wave
Recently I noticed that my settings for power reporting return to default for the Aeotec ZW-078 High Amp switch. I only am able to report volts but nothing else. Anyone elase see the same problem. My Aeotec Smart switch 6's are not a problem. All I see in my logs are voltage being reported. Not sure if this happened when I upgraded to ZWAVE .199.
HomeSeer Version: HS3 Standard Edition 3.0.0.418
Operating System: Microsoft Windows Embedded Standard - Work Station
System Uptime: 11 Days 11 Hours 8 Minutes 46 Seconds
IP Address: 192.168.1.215
Number of Devices: 470
Number of Events: 48
Available Threads: 200
HSTouch Enabled: True
Event Threads: 0
Event Trigger Eval Queue: 0
Event Trigger Priority Eval Queue: 0
Device Exec Queue: 0
HSTouch Event Queue: 0
Email Send Queue: 0
Anti Virus Installed:
Enabled Plug-Ins
3.2.0.5: APCUPSD
1.2.2.0: Device History
3.0.0.103: LutronCaseta
3.0.5.7: SDJ-Health
3.0.6331.36036: UltraCID3
3.0.6616.28548: UltraM1G3
3.0.6554.33094: UltraMon3
3.0.5902.19061: UltraSMTP3
3.0.5712.31691: UltraWeatherBug3
3.0.1.199: Z-Wave
Recently I noticed that my settings for power reporting return to default for the Aeotec ZW-078 High Amp switch. I only am able to report volts but nothing else. Anyone elase see the same problem. My Aeotec Smart switch 6's are not a problem. All I see in my logs are voltage being reported. Not sure if this happened when I upgraded to ZWAVE .199.