I added a new ApplianceLinc and noticed that it did not have a link that says 'Switch/Load has local control reporting to Homeseer'. My other switches like SwitchLinc have this entry. Sure enough, when I turned on the ApplianceLinc from the module itself, its status in Homeseer was not updated.
I can control the ApplianceLinc from homeseer though, so this is not a signal issue.
Is it possible to have the ApplianceLinc report its status to Homeseer when it's turned on or off from the module? Thanks.
I can control the ApplianceLinc from homeseer though, so this is not a signal issue.
Is it possible to have the ApplianceLinc report its status to Homeseer when it's turned on or off from the module? Thanks.
Comment